How To Washing Your Hair In The Shower With Your Wig On
Публикувано на: 13 Ное 2019 09:33Sometimes you have to wear the for several days and don’t want to take off while having a shower. You can wash a lace wig while keeping it on your head, but you must be more careful than you would be while washing your own natural hair.
First, be sure that the adhesive--whether that’s glue, tape, clips or a combination of all three--is still securely on your head and that there’s no peel-up, especially around your edges. If your is already starting to come off, washing it while on your head is not a wise option.
Second, be aware of the length of your natural hair. If your natural hair underneath your wig is only an inch or two long, it will dry quickly. However, if your is long, then it will take a long time to properly dry under your wig. Keep this in mind.
Third, in the shower, tip your head back and gently wet it. You always want the water to be flowing down from the back of your head, because that is gentler on your bonds, especially in the front. If you stand facing the shower so that the water directly hits your wig, the water may pull them loose.
Lather your hair very gently using a shampoo created especially for wigs or a shampoo made for fragile hair. You only need one wash in order to remove the oils and the perspiration that has built up over the past several days.
After your shower, gently pat your hair dry. Check the bond to see if it’s still tight or if it’s begun to come loose. The adhesive might have turned white in the shower, but you’ll know when you’re done drying your hair because the adhesive will turn clear again. Or when you want to go out, you can glue the lace again to make sure it is secure.
Spray it with a special leave-in created for wigs. The spray is lighter than a cream, which may weigh the hair down. Then, from the sides and working toward the bond, detangle the wig with a brush from your ends to your roots. Re-clip or re-glue any parts of the wig that have begun to come loose. Finally, use a wide-tooth comb to fluff the wig up and blow-dry it to diffuse it.
You just want to be sure you are very gentle while doing so. Focus on getting the hair strands clean, do not massage as you would your normal hair. Once finished, gently towel dry and blow-dry on low or just let it air dry by itself. You may then apply a conditioner for about 5-10 minutes, then rinse thoroughly.
AlipearlHair Website：https://www.alipearlhair.com
First, be sure that the adhesive--whether that’s glue, tape, clips or a combination of all three--is still securely on your head and that there’s no peel-up, especially around your edges. If your is already starting to come off, washing it while on your head is not a wise option.
Second, be aware of the length of your natural hair. If your natural hair underneath your wig is only an inch or two long, it will dry quickly. However, if your is long, then it will take a long time to properly dry under your wig. Keep this in mind.
Third, in the shower, tip your head back and gently wet it. You always want the water to be flowing down from the back of your head, because that is gentler on your bonds, especially in the front. If you stand facing the shower so that the water directly hits your wig, the water may pull them loose.
Lather your hair very gently using a shampoo created especially for wigs or a shampoo made for fragile hair. You only need one wash in order to remove the oils and the perspiration that has built up over the past several days.
After your shower, gently pat your hair dry. Check the bond to see if it’s still tight or if it’s begun to come loose. The adhesive might have turned white in the shower, but you’ll know when you’re done drying your hair because the adhesive will turn clear again. Or when you want to go out, you can glue the lace again to make sure it is secure.
Spray it with a special leave-in created for wigs. The spray is lighter than a cream, which may weigh the hair down. Then, from the sides and working toward the bond, detangle the wig with a brush from your ends to your roots. Re-clip or re-glue any parts of the wig that have begun to come loose. Finally, use a wide-tooth comb to fluff the wig up and blow-dry it to diffuse it.
You just want to be sure you are very gentle while doing so. Focus on getting the hair strands clean, do not massage as you would your normal hair. Once finished, gently towel dry and blow-dry on low or just let it air dry by itself. You may then apply a conditioner for about 5-10 minutes, then rinse thoroughly.
AlipearlHair Website：https://www.alipearlhair.com